Mitts, knitted spokes

The model is made spokes.

You’ll need: 80 g yarn gray color (50 % wool, 50 % acrylic, 250 m x 100 g); set stocking spokes № 4,5; 2 buttons on the “legs “ of the needle.

Mitts, knitted spokes

Attention! To the dimensions of the product match the desired (see Fig. 1) run the sample basic pattern of figure 1, determine the density of knitting. According to the model and patterns make the calculation of loops. Mitts for the right dial on the spokes of loops and distribute them on 4 needles and knit in a circle cuff elastic 1×1. After 3 cm from the edge of typesetting continue the work of the “pearl” pattern, proverite 3 cm straight, then make an extension for the thumb, adding the 2 loops at one time, and including adding loops in pattern. After 8 cm from the cuff make a hole for the thumb as follows: close the loop on the segment of length 6 cm In the next row, type over closed loops new loops, whose number must be two times smaller closed loops (length 3 cm). Finished knit elastic 1 x 1 height 2 cm Loop close. For decoration tie a rubber band 1 x 1 plastron width of 3 and length of 10 cm, sew it along the short side of the cuff under the slit for the thumb. The second end lock using the buttons. Left mitenko run symmetrically.

Mitts, knitted spokes